Stellar External Media Recovery/4. Working with the Software/4.6. Save and Load Scan Information

4.6. Save and Load Scan Information

You can save the scan results of a process to resume the recovery at a later stage. This helps you resume the recovery process without scanning the image again. It is advisable to let the scan complete before saving the scan as you can recover data that is listed in the saved scan.

To save scan information:

1. In the ‘Scan Results‘ window. ClickBackbutton or close the application. Or, click onicon and select theSave Scanoption.

2. You will be prompted to save the scan information.

3. ClickYes.

4. In ‘Save scan information‘ dialog box, specify the location where you want to save the image file. Type the name of the image file in theSave Astext box. ClickSave.

5.Scan Information file will be saved.

Note:If you stop a scanning process, you can save the scan information up to that point. However, you should perform a complete scan, and then save the scan result.

Tip:It is recommended that you should save ‘scan information file’ and ‘hard disk image’ at different locations with proper name so that you can easily retrieve the required file.

To load the previously saved scan information

This option is used to resume the recovery process from a saved scan information file.

1. Run theStellar External Media Recovery.

2. Click onicon and select theLoad Scanoption.

3. ALoad Scanwindow will appear which displays a list ofSaved Scan Informationfile existing in the system.

4. In case the file you desire is not in the list, click添加button to add the desired file.

5.的file you added gets displayed in the load scan window. ClickRemovebutton if you want to remove the save scan file.

Note: If you want to reset the load scanned list, click onResetbutton.

7. ClickRecoverbutton. A screen showing the scanning process is displayed.

Note: You can select only one file at a time to start the process of scanning.